News

Harold's Hints: Finding the model # on a Briggs and Stratton

  Parts and repairs in Carlsbad, NM The model number on an engine is needed for many things including ordering parts, getting a warranty, and looking up any information for it. These numbers are sometimes hard to find and this video shows you where to find it on a Briggs engine which is very common in mowers. Check it out! How to get the model number on a Briggs and Stratton askthemowerguy.com carlsbad small engine

Read more →


Harold's Hints: Looking up model # on a Honda engine

  Parts and repairs in Carlsbad, NM You may need the model number off of your engine for a number of things, getting a part for it, securing a warranty, or looking up any information for it. Sometimes they can be very obscure and hard to find. This video helps you find the model number on an Honda engine. Check it out! Look up model on Honda engine

Read more →


Harold's Hints: Briggs and Stratton clutch recoil assembly

  Parts and repairs in Carlsbad, NM While a lawnmower may not seem all that complicated as a piece of equipment that you push or ride around on cutting up grass, but it is. A lot of mechanical components come together to allow the engine to run and the blade to spin to get the job done. This video gives you a glimpse at that complexity. It breaks down a clutch recoil assembly on a Briggs and Stratton, and also gives you advice on cleaning and maintaining it. Check it out! Briggs and Stratton clutch recoil assembly

Read more →


Harold's Hints: Bad gas in your mower

  Parts and repairs in Carlsbad, NM Running bad gas in your mower is a serious no no. It causes your engine to run poorly causes mechanical problems in the long run. Be sure to check your gas every time you used your mower or any piece of equipment for that matter. Look at this video below to help you determine what bad gas looks like and how to drain it out. This is what bad gas in your lawn mower look like by ask the mower guy and Carlsbad Small Engine  

Read more →


Harold's Hints: How to drain gas out of a small engine

  Parts and repairs in Carlsbad, NM Some times when an engine is running unsteady or dies, the problem may not be mechanical. Simple problems should always be looked for first before you begin to tear apart the engine. For example, does it have an adequate amount of gas and oil? Does the gas appear to be good? Well this video shows you how to check for bad gas, and how to drain it out of the engine if that were to be the problem. Check it out! How to drain bad gas out of a Briggs or Kohler

Read more →